Slow speeds spread material close and densely.
Fast speeds spread material far and thinly.
4.
Drive at a consistent speed as you spread
material.
5.
When you are finished spreading, turn the
spreader off.
Freeing a Clog
If the clog is not cleared automatically, turn off the
machine, disconnect the spreader wire harness, and
manually free the clog.
Adjusting the Material
Deflectors
1.
Turn the material deflector knob counter
clockwise to loosen the material deflector.
2.
Slide the material deflector into the desired
position.
3.
Turn the material deflector knob clockwise to
tighten the material deflector.
g382948
Figure 22
Unloading the Spreader
1.
Position the spreader in the area where you
want to deposit the material.
2.
Turn on the spreader controller and run the
spreader until the hopper is empty.
Cleaning the Spreader
Service Interval:
Before each use or daily—Clean
the spreader.
Important:
Do not use water to clean the
spreader.
Use compressed air to clear debris and materials from
the spreader and hopper.
11
