Installing the Hydraulic
Hoses
Refer to
when installing the hoses to the
hydraulic shelf.
g036650
Figure 9
1.
C1 to the left push-frame
cylinder
5.
C2 to the right push-frame
cylinder
2.
Aux to the upper fitting on
the lift cylinder
6.
L to the lower fitting on the
lift cylinder
3.
XR2 to the outer fitting on
the right wing-cylinder
7.
XR1 to the inner fitting on
the right wing-cylinder
4.
XL2 to the outer fitting on
the left wing-cylinder
8.
XL1 to the inner fitting on
the left wing-cylinder
1.
Connect a 1.8 m (73-1/2 inch) hose to the XL2
port on the hydraulic shelf, and a 1.5 m (59-1/2
inch) hose to the XL1 port (
). Turn the
fitting until it is finger tight, then turn it another
1/4 to 1/2 turn.
Important:
Do not overtighten.
2.
Slide the 2 hoses through 2 pieces of hose wrap
as shown in
.
3.
Secure the hoses to the left hose-clamp using a
bolt (5/16 x 2-1/2 inches) and nut between the 2
sections of hose wrap (
).
4.
Using thread compound, install 90° fittings to the
left wing extension cylinder (
).
Note:
The fittings should point toward the
center of the plow.
5.
Connect the 1.5 m (59-1/2 inch) hose to the
inner fitting on the left wing-cylinder (
).
Turn the fitting until it is finger tight, then turn it
another 1/4 to 1/2 turn.
Important:
Do not overtighten.
9
Summary of Contents for RT3 EXT
