Boss Snowplow MSC23000, Owner'S Manual, Page: 6 / 12

using 2 washers (1/2 inch) and nylon locknuts
(
Figure 5 ).
7. Tighten the nylon locknuts until there is a gap of
0.8 mm (1/32 inch) between the trip spring coils.
Installing the Hydraulic
Hoses
1. Remove the crossover cover ( Figure 6 ).
g297806
Figure 6
1. 90° fitting 3. Crossover cover
2. Male fittings 4. Female fittings
2. Using thread compound, install a 90° fitting on
each angle cylinder located on the push-frame
assembly (
Figure 6 ).
3. Using thread compound, install 2 female fittings
to the left side of the hydraulic block (
Figure 6 ).
4. Using thread compound, install 2 male fittings to
the right side of the hydraulic block (
Figure 6 ).
5. Install the female end of the medium hose to the
90° fitting on the right angle-cylinder (
Figure 7 ).
Turn the fitting until it is finger tight, then turn it 2
to 3 more times.
g297807
Figure 7
1. Medium hose 2. Short hose
6. Install the male end of the medium hose to the
front-left fitting on the hydraulic block (
Figure 7 ).
7. Install the female end of the short hose to the
90° fitting on the left angle-cylinder (
Figure 7 ).
Turn the fitting until it is finger tight, then turn it 2
to 3 more times.
8. Install the male end of the short hose to the
back-left fitting on the hydraulic block (
Figure 7 ).
9. Install the 90° fittings of the long hoses to the
fittings on the right side of the hydraulic block
(
Figure 8 ).
6