Boss Snowplow Drag Pro 180Z, Owner'S Manual

Page: 19 / 32

g337014
Figure 39
6. Measure the distance between the hitch
assembly and the vehicle bumper. A minimum
of 5.1 cm (2 inches) is required; adjust the hitch
rail length to achieve proper clearance.
7. Secure the hitch receiver onto the vehicle using
the hitch pin.
g334867
Figure 40
Mounting the Plow
Note:
The vehicle must be running before starting
this procedure.
1. Turn on the plow controller.
2. Ensure that the controller is not in FLOAT mode.
3. Line up the vehicle with the snowplow and slowly
drive backward until you are close enough to
connect the plow wire harness to the vehicle
wire harness.
4. Remove the electrical-plug dust-covers and
connect the plow wire harness to the vehicle
wire harness.
5. Use the coupler switch to raise or lower the plow
to the desired height, then slowly drive backward
until the attachment arms contact the slots on
the rail mounting kit (
Figure 41 ).
6. Lower the plow onto the hitch and flip the
pin-locking levers to engage them (
Figure 41 ).
g335629
Figure 41
7. Ensure that the hitch assembly or plow does not
obstruct the taillight visibility.
Important:
If the taillights are obstructed
by the hitch assembly or plow, auxiliary
taillights must be installed to comply with
federal regulations.
19