7
8
ENGLISH
ENGLISH
PAIRING & DISCOVERING A NEW BLUETOOTH CONNECTION
1) Power on the
MC900B
by pressing and holding down the
Power
2
button for 2
seconds, the Bluetooth blue LED will start to flash, and a confirmation tone will be heard
from the speakers signalling that the
MC900B
is now ready for Bluetooth pairing.
NOTE:
You have 2 minutes before you must restart this procedure over again.
2) Now that the
MC900B
is in pairing mode:
ANDROID users:
a. Go into the
Settings Menu
of your device
b. Enter the
Bluetooth Menu
and press
SCAN
c.
“MC900B”
will now be display under
AVAILABLE DEVICES
d. If prompted, enter passcode: “
0000
”
iOS users:
a. Go into the
Settings Menu
of your
iOS
device
b. Enter the
Bluetooth Menu
c.
“MC900B”
will now be displayed
d. If prompted, enter passcode: “
0000
”
3) If the
MC900B
is not seen, repeat the above steps to refresh the “
Device List”
4) When the connection is successful you will hear a confirmation tone, you are now ready
to stream music from your devices favorite media player to the
MC900B
BLUETOOTH OPERATION
2
Tips:
EN
Nyne Cruiser
USB CHARGE
5V 1A
Tips:
EN
Nyne Cruiser
USB CHARGE
5V 1A
To avoid battery exhaustion be sure to run the vehicles engine
while using this product. Using this product without running the
engine can drain the battery.
Tips:
EN
Nyne Cruiser
USB CHARGE
5V 1A
BLUETOOTH OPERATION
RECONNECTION
1) Power on the
MC900B
and your last paired device Bluetooth.
2) The unit will now automatically reconnect, and a confirmation tone will be heard from the
speakers
3) If your device was previously paired with the
BOSS AUDIO MC900B
, but it wasn’t the
last paired device:
a. Ensure no other devices are currently paired
b. Enter the
Bluetooth Menu
on your device being paired
c.
“MC900B”
will display under
AVAILABLE DEVICES
d. Choose the
“MC900B”
to reconnect
4) If the device is out of range from the
MC900B
, it will disconnect automatically:
a. To reconnect once device is back in range, press the
Power
2
button once
b. The
MC900B
will now reconnect to the device, a confirmation tone will be heard
from the speakers
CLEARING PREVIOUSLY PAIRED DEVICES MEMORY
1) Quick press the
POWER
2
button
2X
, all
BLUE LED’s
will start to flash
2) Press and hold the
PLAY/PAUSE
5
button for 10 seconds, a confirmation tone from
the speakers will be heard, the
LED’s
will stop flashing, now only the
BT LED
will flash
3)
PAIR
a new device as described on
PG 8
2
Tips:
EN
Nyne Cruiser
USB CHARGE
5V 1A
Tips:
EN
Nyne Cruiser
USB CHARGE
5V 1A
5
