3
4
ENGLISH
ENGLISH
GROUND CABLE
METAL FRAME
(R) OUTPUT RED
(L) OUTPUT WHITE
PRE-AMP OUTPUT
FUSE REPLACEMENT
WITH ATO TYPE ONLY
15 AMP
(R) INPUT RED
(L) INPUT WHITE
AUX INPUT
USB
CHARGING
(1A MAX)
REMOTE
CONTROL
4-OHM
SPEAKERS
WHITE
GRAY
GREEN
VIOLET
LEFT
CHANNEL 1
RIGHT
CHANNEL 1
LEFT
CHANNEL 2
RIGHT
CHANNEL 2
WHITE/BLK
GRAY
GREEN/BLK
VIOLET/BLK
+
-
+
-
+
-
+
-
+12V YELLOW
REMOTE OUT
(500mA MAX)
ORANGE
+12V BLUE
IGNITION
BATTERY
+12V RED
20A
CHASSIS
GROUND
POINT
BATTERY
DIRECT BATTERY
WIRING CIRCUIT
BLACK
OPTIONAL
FUSE AND FUSE HOLDER
(NOT INCLUDED)
INSERT
CHASSIS
GROUND
POINT
PINK
ANTENNA
(DO NOT CUT)
15
OPTIONAL BACKLIGHTING
ON/OFF CONTROL
(DO NOT GROUND OR
CONNECT TO +12V)
WIRE DIAGRAM
BEFORE INSTALLING THIS PRODUCT
When replacing the fuse, be sure to only use a fuse of the
rating specified on this product.
To avoid short-circuiting, cover any disconnected leads with insulating tape. It is
especially important to insulate any unused wires, which if left uncovered may
cause a short circuit. When connecting other devices to this product, refer to the
manual for the product to be connected. The black cable is ground, make sure to
connect the ground wire first.
Ensure that the ground cable is properly connected to metal parts of the vehicles
body frame or direct to the battery if your vehicle does not have a grounded
chassis frame The ground cable of this units power amp and a second powered
system must be connected to the frame separately with different screws. If the
screw for the ground wire loosens or falls out, it could result in fire or malfunction.
To avoid potential shorts in the
electrical system, be sure to disconnect
the (–) battery cable before installation.
Use this unit with a 12-volt battery and
negative grounding only. Failure to do so
may result in a fire or malfunction.
TOOLS NEEDED:
- Wrench and/or Pliers
- #2 Phillips screwdriver
- Crimp tool
- Electrical tape
TECHNICAL SUPPORT
1-800-999-1236
www.bossaudio.com/support
CAUTION!! Do not ground or short the PINK antenna wire
