w
w
STEP 4
Use a centre punch to ensure that the drill does not wander. Starting with a 5mm drill
bit, drill your marked holes and finish with a 9mm bit. It is recommended to deburr your
holes.
A
B
STEP 5
We recommend test fitting your awning before using silicone and thread locker.
Clean area and put silicone around each hole for the external and internal mounting
plates. This will prevent any water or dust from entering.
A
B
STEP 6
Ensure that you have all necessary washers and split washers.
Apply thread locker to your supplied bolts.
Get your helper to hold the external plate onto the tent and feed the bolts through.
Place the internal mounting plates over the bolts and tighten the supplied nylon nuts.
Ensure that these are evenly tightened.
A
B
