E N G L I S H - 3 5
A P P E N D I X A : I N S TA L L AT I O N R E F E R E N C E
Connecting an OmniJewel
™
base
1. Using the screwdriver, turn the screws to the left (counterclockwise) to loosen the
wire terminals on the bases.
2.
For front speakers
: Insert the bare ends of the four-pin cable into the OmniJewel™
base by placing the red wire marked
L+
or
R+
into the red terminal (
+
) and the plain
wire into the plain silver terminal (
–
).
For rear speakers:
Insert the bare ends of the two-pin cable into the OmniJewel™
base by placing the red wire marked
+
into the red terminal (
+
) and the plain wire
into the plain silver terminal (
–
).
3. Use the Phillips head screwdriver to secure the wires into the terminals by turning
the screws on top of the base to the right (clockwise).
4. While holding the OmniJewel™ speaker, place the base into the bottom.
The base should fit flush into your speaker, with the wire terminals facing the back.
5. Attach the base to the speaker by pushing the Phillips head screwdriver through the
circular opening and turning the screw to the right (clockwise) until fully seated.
