24
Svens
k
a
N
e
d
e
rl
a
n
d
s
It
alian
o
Fran
çais
E
spaño
l
Deuts
c
h
D
an
sk
EnglishDansk
Deutsch
Italiano
Nede
rla
nds
Svens
k
a
F
ra
nçais
E
sp
añol
English
O
PERATING
I
NSTRUCTIONS
Producing individualized sound
This product will produce sound whether it is properly adjusted or not. However, if you take a
few moments to follow a simple startup procedure, you can optimize the sound for a superior
presentation based on your performance style and preferences.
Unless you make big changes in how you perform, this is typically a one-time event.
1.
Set all
Trim
and
Level
controls on the L1 model I power stand to zero (0).
2.
Set the
MASTER
and all
LEVEL
controls on the R1 remote control to zero (0).
3.
Set the
Power
switch to
On
.
CAUTION:
The peak inrush current for the system is approximately 32 amps. If more than one
system is plugged into the same AC circuit, make sure you stagger the turn-on times. This can
prevent tripping the circuit breaker or blowing the house mains fuse.
4.
Plug your microphone or instrument into the
Channel 1
or
2
Input
jack. If phantom
power is required for your microphone (condenser or electret/condenser type), depress
the
Phantom
power button.
Note:
You can dial in a preset to improve the tone of many commonly used microphones and
musical instruments. See the preset list inside the rear panel door for a list of supported
instruments.
5.
Sing or play as loud as you would in a performance while following steps
6
and
7.
6.
Adjust the
Trim
control so that the
Signal/OL
indicator goes from unlit to green, and
finally to occasionally blinking red. Make sure that your instrument is at the highest
volume setting that you are planning to use. For vocalists, sing as loud as you would
during the performance to achieve the maximum expected input signal.
7.
Adjust the
LEVEL
control on the R1 remote control and make the
SIG/OL
indicator go
from unlit to green, and finally to occasionally blinking red.
That’s it! You’re done! When you go to your concert or show:
• Use the
CH 1
and
2 LEVEL
controls on the R1 remote control to adjust the
Channel 1
and
2
volume level.
• Use the
MASTER
control on the R1 remote control to adjust the volume level of all
outputs.
• Use the
HIGH
,
MID
, and
LOW
equalization controls on the R1 remote control to adjust the
timbre of your sound.
Initially, keep the R1 remote control close at hand. This allows you to conveniently adjust the
volume level when you first start playing. Later, you can move it out of the way or backstage
once the system is performing the way you want it to.
Note:
For more information on presets and amplifying the true sound of your instrument(s),
please visit
www.Bose.com/musicians
.
Using input channels 3 and 4
The
Channel 3
and
4
inputs are optimized for 0 dB line-level signals, such as the signals from
an effects processor, mixer, or CD player. Simply connect the equipment to the L1 model I
power stand and raise the output level using the
Channel 3
and
4 Level
control on the rear
panel of the L1 model I power stand.
PIASOG.book Page 24 Wednesday, February 14, 2007 3:10 PM
