__________________________________________________________________________________________
extrusion has been properly levelled using a spirit (or
bubble) level.
●
Recessed Installation:
Make a cut-out into the ceiling
or wall as per the required cut-out dimensions.
Mounting accessory depends on the type or design of
the extrusion. For extrusion with spring clips, install
first the spring clips into the extrusion then push
upward the spring clips while carefully placing the
extrusion into the ceiling or wall. The spring clips will
then hold the extrusion firmly into place.
For clips/brackets, install first the clips/brackets into
the extrusion with the provided screws then position
the extrusion in place. Drive the screws of the
recessed clips/brackets which will spin and stop to the
correct angle position. As you keep driving the screws,
the gap between the clips/brackets and the ceiling will
be narrowed down then eventually will hold the
extrusion firmly into place
STEP 4:
Double check the electrical wirings and
connections before turning on the power to the
aluminium LED profile or
extrusion.
Maintenance
●
Make sure that the power to the
aluminium LED
profile or extrusion
has been turned off and has given
the time to cool down after being used before you
start of cleaning the lighting fixture. Cleaning must be
done at interval schedules to ensure to have a better
lighting.
●
Use damp clean cloth to wipe the dirt that adhered to
the light fitting. Never try to immerse the light fitting
and its components in water.
●
Use static free gloves when cleaning the luminaire to
avoid markings.
Disclaimers
●
BoscoLighting is not liable where :
○
There is product malfunction and or any damages
caused by improper use or installation.
○
Installation has not completed by licensed
electricians.
○
Safety instructions have not been properly
followed.
○
Damage due to site issues such as voltage surges,
rodent damage or vandalism.
●
Kindly be advised that the aluminium LED profile are
not specifically designed to be installed on hazardous,
corrosives and or flammable areas.
●
The aluminium LED profile has been designed to
operate at an ambient temperature of -10°C to 45°C.
●
Aluminium LED profile found out to be tampered with
or have been tried to be repaired apart from the
supplier/manufacturer during the warranty period
shall void the warranty of the product. Hence, any
damages caused by the said act will not be
BoscoLighting’s liability.
●
BoscoLighting has the right to modify or obsolete the
design of its products for quality improvement or due
to supplier constraints.
●
Products may appear different to product data sheets
or installation instructions.
3
