en
Faults and what to do about them
22
Note:
If you cannot rectify the fault yourself by turning the dryer off and on, please
contact our after-sales service.
Drying time too long?
■
The fluff filter may be dirty and cause drying to take longer. Clean the fluff
filter.
■
If the air inlet on the dryer is blocked or not freely accessible, this may
increase the drying time. Make sure that the air inlet remains unobstructed.
■
If the ambient temperature is higher than 35 °C, this may extend the drying
time.
■
Insufficient air circulation in the room may increase the drying time. Venti-
late the room.
Display panel goes off
and Start button flashes.
Not a fault. Energy saving mode is active
~
Page 6
.
Residual water in the
condensation container
despite the dryer being
connected to the con-
densation drain*.
Not a fault. If the condensation drain is installed, residual water remains in the
condensation container due to the dryer's self-cleaning function.
Humidity in the room
increases.
Not a fault. Make sure the room is sufficiently ventilated.
Power cut.
The drying programme is interrupted. Remove the laundry and spread it out, or
restart the programme.
Unusual noises when
drying.
Not a fault. Noises are produced by the automatic cleaning of the heat
exchanger
~
Page 19
.
The dryer feels cold
despite drying.
Not a fault. The dryer can dry efficiently at low temperatures using a heat pump.
Faults
Cause/remedy
* depending on the model
Summary of Contents for WTW85490GB
Page 1: ...en Installation and operating instructions Tumble dryer WTW85490GB ...
Page 29: ...6 ...
Page 30: ...6 ...
Page 31: ...6 ...
