en
Help with the appliance
40
3
Help with the appliance
Help with the appliance
Faults
Cause/remedy
The appliance will not start.
Check the mains plug and the fuses.
Creasing.
■
Load exceeded or incorrect programme selected for a type of fabric.
All the required information can be found in the programme
table.
■
Remove laundry from the drum as soon as the drying programme
has finished. Creasing occurs when clothing is left in the drum.
Water is leaking out.
■
The appliance may be positioned at an angle. Level the appliance.
■
In the base unit, make sure that:
– The heat exchanger cover is properly locked.
– There is no dirt or debris on the heat exchanger cover's seal.
■
If the optional drain hose* is installed, make sure that the drain hose
is correctly connected.
The appliance is paused but the
drum is turning.
The appliance has detected a high temperature and has started the
CoolDown process. Temperature regulation can take up to 10 minutes.
You can cancel the CoolDown process at any time by opening the door.
The programme will not start
Make sure that:
■
The door is closed.
■
E
3sek. (Childproof lock) has been deactivated
■
You have pressed Start/Pause//Départ/Pause (Start/Pause)
Note:
If the programme has been delayed by setting
Fertig in/Fin dans
(Ready in)
, the programme will start later.
Programme duration displayed
changes as drying progresses.
Not a fault. The moisture sensor measures the residual moisture in the
laundry and adjusts the programme duration (with the exception of timed
programmes).
Laundry is not dried properly or
is still too damp.
■
After the programme has ended, warm laundry feels damper than it
actually is. Spread out the laundry and let it cool down.
■
Adjust the drying time or increase the degree of dryness. This will
extend the drying time but the temperature will remain the same.
■
Select a timed programme to add extra drying time for laundry that is
still damp.
■
Select a timed programme for a small load.
■
Do not exceed the maximum load for a programme.
■
Clean the moisture sensor in the drum. The sensor may become cov-
ered in a fine layer of limescale or detergent and care product resi-
due, which then impairs its performance.
■
Drying has been interrupted as a result of a power cut, because the
condensation container is full or because the maximum drying time
has been exceeded.
Note:
Summary of Contents for WTR83VF0CH
Page 1: ...en Installation and operating instructions Tumble dryer WTR83VF0CH ...
Page 46: ...6 ...
Page 47: ...6 ...
