en
Cleaning and maintenance
36
Cleaning the moisture sensor
Note:
The moisture sensor measures
the amount of moisture in the laundry.
After long periods of usage, the
moisture sensor may become covered
by a fine layer of limescale or detergent
and care product residue. These
deposits must be removed regularly,
otherwise the drying results may not be
optimal.
1.
Open the door.
2.
Clean the moisture sensor with a
rough sponge.
Caution!
Risk of damaging the moisture sensor.
The moisture sensor is made from
stainless steel. Do not clean the sensor
with abrasive cleaning products or wire
wool.
Cleaning the base unit
Fluff and hair from the laundry collect in
the base unit during drying. Clean the
appliance's base unit if the following
message appears in the display:
ç
.
You can also clean the appliance's
base unit even if this message does not
appear in the display, e.g. if there is
visible soiling.
:
Warning
Risk of injury!
You could cut your hands on the sharp
fins on the heat exchanger.
Do not touch the fins on the heat
exchanger with your hands.
Note:
Allow the appliance to cool down
for approximately 30 minutes after use
before commencing cleaning.
Clean the base unit as follows:
1.
Clean the fluff filter.
2.
Open the maintenance flap by the
handle.
3.
Clean the maintenance flap with a
soft, damp cloth.
Summary of Contents for WTR83VF0CH
Page 1: ...en Installation and operating instructions Tumble dryer WTR83VF0CH ...
Page 46: ...6 ...
Page 47: ...6 ...
