27
Default Program and Option settings
At the factory initial settings are pre-set for all cycles.
You can change some program settings as follows.
Dry Level
The dryness level can be increased in 3 steps (i.e. the
laundry is drier) by touching the
Dry level
button for
certain programs.
Default setting = 0 (No LED Symbol shown)
Selectable values: 0, +1, +2, +3
After the dryness level for a program is set, it is retained
until changed again.
Time Dry
Available only for Time programs,
~
Program selection table; Page 26
can be selected from minimum 20 minutes to maximum
3 hours, in 10-minute steps.
Finish in
The program end (Finish in) time can be set in one hour
increments to a maximum of 24 h (hours).
After selecting the desired drying program (at the dial)
but before touching the Start button, touch the
Finish in
button until the desired time is displayed, e.g. 8 h, then
touch the Start button to start the dryer.
NOTICE:
The cycle duration is included in the set Finish
in time.
Here is an example of 2hr:30 min cycle time and an
8
h
Finish in time.
8
h is displayed (until Energy-Saving mode
activates) and counts down (approximately 5hr:30min)
until the drying cycle begins (at 2hr:30min) then the cycle
duration
2:30
is displayed and drying begins. Total time
approximately 8 hours.
Additional Program Option settings
Wrinkle Block
To prevent the laundry from creasing or wrinkling, the
dryer drum rotates at specific intervals following the
drying process.
If the
Wrinkle Block
button is touched, this function is set
to 60 (+60m) or 90 (+90m) minutes.
The laundry remains loose and fluffy until it is removed.
The laundry should be removed before this time has
elapsed.
Low Heat
Reduced temperature for delicate fabrics, e.g.
polyacrylic, polyamide or elastane, with longer drying
time.
Observe the care information or symbols on the textile’s
label.
Spin speed
The
Spin Speed
setting is based on your washer’s
normal spin speed. Adjusting this setting allows the
dryer’s displayed time to be as close as possible to the
actual drying time.
NOTICE:
The spin speed is not the same as the rotation
speed of the dryer drum.
To change the dryer’s
Spin Speed
setting follow the
instructions below.
Activate adjustment mode
1.
Select
Cotton Extra Dry
on position 1.
The appliance is on.
2.
Touch and hold
Start/Pause
and turn the program
selector to the right (position 2). Release
Start/Pause
button.
Adjustment mode is now activated and the default value
(1000 rpm) appears in the display.
2II
