en
Faults and what to do about them
34
Note:
If you cannot rectify the fault yourself by turning the dryer off and on, please
contact our after-sales service.
Drying time too long?
■
The fluff filter may be dirty and cause a longer drying time. Clean the fluff fil-
ter.
■
Unsuitable programme selected?
■
Dryer installed too closely to other objects? Provide adequate air circulation.
■
If the ambient temperature is higher than 35 °C, this may extend the drying
time.
■
Insufficient air circulation in the room may increase the drying time. Ventilate
the room.
■
Mains failure? Restart the dryer.
Condensation in the
exhaust air duct.
Exhaust air duct too long? Check the maximum exhaust air duct lenght. Futher
Displayed drying time
changes during drying
process.
Not a fault. The moisture sensors detect the remaining moisture in load and cor-
rect the programme lenght (except timed programmes).
Humidity in the room
increases.
■
Not a fault. Make sure the room is sufficiently ventilated.
■
Exhaust air duct installed/the exhaust air routes directly into the open air?
One or more indicator
lights are flashing.
■
Clean the fluff filter
■
Check the installation condition
.
■
Exhaust air duct blocked or bent? Clean the exhaust air duct
■
Switch off, allow to cool, switch back on, and restart the programme.
Power cut.
The drying program is interrupted. Remove the laundry and spread it out, or
restart the program.
Note:
Be careful as the door , the drum and the laundry may be hot.
Faults
Cause/remedy
* depending on the model
Summary of Contents for WTA74202ID
Page 1: ...en Installation and operating instructions Tumble dryer WTA74202ID ...
Page 38: ...6 ...
Page 39: ...6 ...
