23
Service
From F02 to
F35
F06
FA
Fault in an electrical component.
Start the "Drain” programme or press and hold the
"Clear/drain” button for at least 3 seconds.
Check whether the correct programme has been se-
lected for the type of laundry, and whether the maxi-
mum load has been observed (see programme table).
Press and hold "Clear” for at least 3 seconds; the pro-
gramme is cancelled. Then select a suitable pro-
gramme for the type of laundry.?
Fault in the Aqua-Stop device.
Switch off the appliance, pull out the mains plug, turn
off the tap.
Carefully tip the appliance forwards. Allow the water to
drain out of the appliance base. Then:
– Connect the mains plug
– Turn the tap on
– Restart the programme
Service
Fod
Excessive foaming
Programme interrupted because of excessive foam-
ing
– Start the Rinse and spin programme.
– Restart the desired programme. Use less detergent
Should the malfunction persist: unplug the mains plug, turn off the tap and call the after-
sales service.
Flashing fault dis-
play
Contents of
display (if
present)
Cause/remedial action
