en
Operating the appliance
38
Adding/removing laundry
After starting the programme (only for
washing), you can add or remove
laundry if necessary.
Touch the
A
(Start/Reload/Pause)
button. The appliance checks whether
reloading is possible.
If the following appears on the display
panel:
■
The symbol
Õ
disappears,
reloading is possible.
■
The symbol
Õ
lights up, reloading is
not possible.
To continue the programme, touch the
A
(Start/Reload/Pause)
button. The
programme continues automatically.
Notes
■
Do not leave the door open for too
long when adding laundry as water
from the laundry may leak out.
■
For safety reasons, the door remains
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
1.
Touch the
A
(Start/Reload/Pause)
button.
2.
Select another programme.
3.
And touch the
A
(Start/Reload/
Pause)
button again. The new
programme starts from the
beginning.
Note:
If drying is activated, after
touching the
A
(Start/Reload/Pause)
button, when the
•©£
is displayed,
waiting for the appliance running to cool
down the laundry till the
•©£
disappears, then select another
programme.
Cancel the programme
For programmes washing at high
temperatures:
1.
Touch the
A
(Start/Reload/Pause)
button.
2.
To cool down laundry: Select
Rinse
.
3.
Touch the
A
(Start/Reload/Pause)
button.
For programmes washing at low
temperatures:
1.
Touch the
A
(Start/Reload/Pause)
button.
2.
Select
Spin/Drain
.
3.
Touch the
A
(Start/Reload/Pause)
button.
For programmes in drying process:
1.
Touch the
A
(Start/Reload/Pause)
button.
2.
If the
•©£
on the display panel,
waiting for the appliance running to
cool down the laundry till the
•©£
disappears.
Programme end
“Ÿš
lights up on the display and
~
and
Õ
displays are off.
If you have selected
2
, the water is only
drained after rinse process, no spin
cycle.
Notes
■
If
•©£
flashes in the display before
the drying programme ends, the
temperature in the drum is high. The
programme for cooling the drum
runs until the temperature in the
drum has dropped.
