Cleaning and maintenance
en
33
4.
Take the auxilary drain hose out of
the holder.
Remove the locking cap and drain
off the water into a suitable
container.
Replace the locking cap and place
the drain hose back in the holder.
5.
Carefully unscrew the pump cover;
remaining water may leak out.
Clean the interior, pump cover
thread and pump housing. The
impeller in the drain pump must be
able to rotate.
Refit and screw on the pump cover.
The handle must be in a vertical
position.
6.
Put the service flap back on, engage
and close it.
Note:
To prevent unused detergent
from flowing into the outlet during the
next wash: Pour 1 litre of water into
compartment
II
and start the
0
Spin/
[
Drain/Empty programme (if only a drain
cycle is required, set rpm (spin speed)
to - 0 -).
The drain hose at the siphon
is blocked
1.
Switch off the appliance. Disconnect
the mains plug.
2.
Loosen the hose clamp. Carefully
remove the drain hose, residual
water may leak out.
3.
Clean the drainage hose and siphon
connecting piece.
4.
Reattach the drainage hose and
secure the connection using the
hose clamp.
Filter in the water supply
blocked
First, reduce the water pressure in the
supply hose:
1.
Turn off the tap.
2.
Select any program (except Rinse//
Spin/Empty).
3.
Press the
A
button.Allow the
program to run for approximately 40
seconds.
4.
Turn the program selector to
Off
.
Pull out the mains plug.
5.
Clean the filter on the tap:
Disconnect the hose from the tap.
Clean the filter with a small brush.
