Bosch WGG256M7NL, User Manual And Installation Instructions

Page: 44 / 56

NL Troubleshooting
Malfunction
Cause and Troubleshooting
Vibration and movement
of the appliance
during the spin
run.
The appliance is not leveled properly.
▶
Adjusting the device
Device feet are not fixed.
▶
Secure the device feet. Adjusting the device
Transport protections have not been removed.
▶
Remove transport protections.
Drum is spinning, er
no water flows into
the appliance.
Load recognition is active.
▶
No error, no action necessary.
Remark: The load detection can take up to 2 minutes.
strong foam
ming.
Detergent dosage is too high.
▶ Immediate measure: mix a tablespoon of fabric softener
with 0.5 l of water and pour this mixture into the left
compartment (not for outdoor, sportswear and down
textiles).
▶
Reduce the amount of detergent for the next wash
with an equal load.
High spin speed
rental is not
reached.
Low spin speed is set.
▶
Set a higher spin speed for the next wash.
Anti wrinkle is activated.
▶
Select a suitable program for the type of fabric.
Unbalance control system compensates for
imbalance through reduced spin speed.
▶
Redistribute the laundry in the drum.
Remark: If possible, place large and small items of
laundry together in the drum. Different sized laundry
is more evenly distributed during the spin cycle.
▶
Start the program Centrifuge.
Program centrifugal
run does not start.
Drain pipe or water drain hose is clogged.
▶
Clean the drain pipe and the water drain hose.
Drain pipe or water drain hose is kinked or
pinched.
▶
Make sure that the drain pipe and the water
drain hose are not kinked or pinched.
The unbalance detection system has interrupted the
spin cycle due to uneven distribution of the laundry.
44