Bosch WGA144A0AU, Instruction Manual And Installation Instructions

Page: 13 / 56

Positioning and connecting
en
13
In addition
, a hose clamp (24 - 40 mm
diameter, available from specialist
retailers) is required to connect the
water outlet hose to a siphon.
Useful tool
■
Spirit level for aligning
■
Wrench with:
– WAF13 for loosening the
transport braces and
– WAF17 for aligning the appliance
feet
Safety instructions
:
Warning
Risk of injury!
■
The appliance is very heavy.
Be careful when lifting/transporting
the appliance.
■
When the appliance is lifted by its
protruding parts (e.g. the appliance
door), the components may break
off and cause injuries.
Do not lift the appliance by
protruding parts.
■
If the hose and mains cables are not
routed properly, there is a risk of
tripping and injury.
Lay hoses and cables in such a way
that there is no risk of tripping.
Caution!
Damage to the appliance
Frozen hoses may rip/burst.
Do not install the appliance in areas
exposed to frost or outdoors.
Caution!
Water damage
The connection points for the water
supply hose and water drain hose are
under high water pressure. To prevent
leaks and water damage, you must
follow the instructions in this section.
Notes
■
In addition to the safety information
listed here, the local water and
electricity supplier may have special
requirements.
■
If in doubt, have the appliance
connected by a specialist.
Installation surface
Note:
The appliance must be stable
aligned so that it does not move
around.
■
The installation surface must be firm
and level.
■
Soft floors/floor coverings are not
suitable.
Installation on a base or a
wooden joist floor
Caution!
Damage to the appliance
The appliance may "wander" and tip/
topple from the base when spinning.
The feet of the appliance must be
secured with holding brackets.
Order no. WMZ 2200, WX 975600,
CZ 110600, Z 7080X0.
Note:
On wooden joist floors, install the
appliance:
■
In a corner, if possible,
■
On a water-resistant wooden board
(min. 30 mm thick) which is screwed
tightly to the floor.