Bosch WAX32K50NL, User Manual And Installation Instructions

Page: 45 / 64

TroubleshootingNL
Malfunction
"E:30 / -80"
Cause and Troubleshooting
▶
When dosing manually, reduce the amount of
detergent for the next wash with an equal load.
Unauthorized extension mounted on the water drain
hose.
▶
Remove any unauthorized extensions from the
water drain hose.
→
"Connecting the device", page 16
Pump cover is not fully screwed in.
▶
Make sure that the pump cover is screwed into the
device as far as it will go. The pump cover handle
must be vertical.
"E:36 / -25 / -26" Drain pump is clogged.
▶
→
"Cleaning the drain pump", page 41 .
"E:38 / -25 / -26" Drain pump is clogged.
▶
→ "Cleaning the drum", page 39
if the fault is displayed again,
▶
→
"Cleaning the drain pump", page 41
Inlet opening of the rubber sleeve is clogged.
▶
→ "Clean the inlet opening in the rubber sleeve",
page 43
"E:10 / -00 / -10 /
- 20"
Pump of the intelligent dosing system is blocked.
1.
Switch off the device.
2.
Clean the pump unit.
→ "Cleaning the detergent drawer", Page
39
3.
Switch on the device.
4.
If the indication reappears after cleaning the pump
unit, call the service.
→
"Customer Service", page 58
Remark:Until the fault has been rectified, you can
deactivate the intelligent dosing system and dose
manually.
→ "Buttons", Page 25
45