Faults and what to do about them.
en
55
The programme is taking
longer than usual.
■
Not a fault – the unbalanced load detection system is adjusting an
imbalance by repeatedly distributing the laundry.
■
Not a fault – the foam detection is system active – a rinse cycle has been
switched on.
The length of the
programme changes
during the wash cycle.
Not a fault – the programme sequence is optimised for the specific washing
process. This may change the length of the programme shown in the display
panel.
Residual water in the
care-product
compartment
v
u
.
■
Not a fault – the effect of the care product is not affected.
Odours in the washing
machine.
Run the
Drum Clean
or
Cottons
90 °C
programme without laundry.
Add washing powder or a detergent containing bleach.
Note: .
To prevent foaming, only use half the amount of detergent
recommended by the detergent manufacturer. Do not use detergent designed
for woollens or delicates.
The
Å
symbol lights up
in the display panel. Foam
may also be leaking from
the detergent drawer.
Have you used too much detergent?
Mix one tablespoon of fabric softener with 1/2 litre of water and pour it into
compartment
v
u
(not suitable for outdoor clothing, sportswear or items
stuffed with down).
Use less detergent in the next washing cycle.
Repeated, intensive
foaming.
■
Check your basic dosage and dosage strength settings.
■
If required, use a different liquid detergent.
Detergent/fabric softener
drips off the seal and
collects on the door or in
the seal fold.
There is too much detergent/fabric softener in the dispensers. Do not fill above
the
max.
mark in the dispensers.
Loud noises, vibrations
and machine "movement"
during the spin cycle.
■
Is the appliance aligned? Align the appliance.
■
Are the appliance's feet fixed? Secure the appliance's feet.
■
Have the transport braces been removed? Remove the transport braces.
The display panel/
indicator lights do not
work while the appliance
is running.
■
Has there been a power failure?
■
Have the fuses blown? Reset/replace the fuses.
■
If the fault occurs repeatedly, call customer services.
There is detergent
residue on the laundry.
■
Some phosphate-free detergents contain water-insoluble residue.
■
Select
Rinse
or brush the laundry after washing.
- P -
appears in the
display panel when the
cycle is paused.
■
The water level is too high. It is not possible to add laundry. Close the door
immediately, if necessary.
■
Press the
A
button to continue the programme.
Faults
Cause/Remedy
