Bosch WAU28PEHSN, User Manual And Installation Instructions

Page: 61 / 76

Troubleshooting
en
61
Fault Cause and troubleshooting
The water is not drain-
ing. Drain pump is blocked.
▶
→ "Cleaning the drain pump", Page 51
is activated.
▶
Continue the programme by selecting
Centrif.
or
Urpumpning
and pressing .
The water outlet hose is connected too high.
▶
Install the water outlet hose at a maximum height of
1 metre.
Detergent dosage is too high.
▶
Immediate measure: Mix one tablespoon of fabric
softener with 0.5 litres of water and pour the mix-
ture into the compartment for manual dosing (not
for outdoor clothing, sportswear or items stuffed
with down).
▶
If intelligent dosing is activated, reduce the basic
dosage →
Page 43 .
▶
If you dose manually, reduce the amount of deter-
gent for the next washing cycle with the same load.
Unapproved extension installed on the water drain
hose.
▶
Remove any unapproved extensions from the water
hose. Connecting the appliance
Water is not flowing
in. Detergent is not
being dispensed. You have not pressed .
▶
Press .
The filters in the water inflow are blocked.
▶
Clean the filters in the water inflow → Page 54 .
The tap is turned off.
▶
Turn on the tap.
The water inlet hose is kinked or jammed.
▶
Ensure that the water inlet hose is not kinked or
jammed.
The spin cycle runs
several times. The unbalanced load detection system eliminates an
imbalance by repeatedly redistributing the laundry.
▶
Not a fault – no action required.
Note:
When loading, where possible, place large and
small items of laundry together in the drum. Different
sized items of laundry distribute themselves better
during the spin cycle.