Bosch WAU28540TC, Instruction Manual And Installation Instructions

Page: 21 / 48

Positioning and connecting
en
21
■
If an earth-leakage circuit breaker is
used, only a type which displays this
symbol is used:
z
.
Only this symbol guarantees
compliance with the currently
applicable regulations.
■
The mains plug can be accessed at
all times.
■
The mains cable is not bent,
squashed, modified, cut through, or
in contact with heat sources.
Before washing for the first
time
The appliance was inspected
thoroughly before leaving the factory. To
remove any residual test water, run the
Drum Clean
programme the first time
without
laundry.
Note:
■
The appliance must have been
installed and connected properly.
~
"Positioning and connecting"
on page 13
■
Never switch on a damaged
appliance.
1.
Insert mains plug.
2.
Turn the water tap on.
3.
Press the
#
button till the indicator
lamp lights up, release the button.
The appliance is switched on.
4.
Close the door. Do not load any
laundry.
5.
Select the
Drum Clean 60°C
programme.
6.
Open the detergent drawer.
7.
Pour approx. 1 litre of water into
dispenser
II
.
8.
Add standard detergent to
dispenser
II
according
to manufacturer’s instructions for
light soiling.
Note:
To prevent over sudsing, use
only half the recommended amount
of detergent. Do not use any
woollens or mild detergents.
9.
Close the detergent drawer.
10.
Select
A
.
11.
When the programme ends, press
the
#
button till the indicator lamp
turns off, release the button.
Your appliance is now ready for use.
Transportation
e.g. when moving home
Preparatory work:
1.
Turn off the water tap.
2.
Reduce the water pressure in the
supply hose.
~
Page 40
3.
Drain any residual water.
~
Page 39
4.
Disconnect the appliance from the
mains.
5.
Remove the hoses.
6.
Empty the dispensers.
~
"Emptying the detergent draw,
cleaning the detergent drawer and
its housing" on page 38 and
Installing the transport locks:
1.
Remove the covers and keep them
in a safe place.
Note:
Use a screwdriver if
necessary.