Faults and what to do about them
en
37
Information on the display panel
Display
Cause/remedy
è
lights up
■
The temperature is too high. Wait until the temperature drops.
■
The water level is too high. It is not possible to add laundry. Close the door
immediately, if necessary. Press the Start Reload
A
button to continue the
programme.
è
flashes
■
Laundry may be caught. Open and close the door again and press the Start
Reload
A
button.
■
If necessary, push the door closed or remove some laundry and then push it
closed again.
■
If necessary, switch the appliance off and on again; set the programme and
make your individual settings; start the programme.
r
lights up
■
Turn on the cold water tap fully,
■
Supply hose kinked/trapped,
■
The water pressure is too low. Clean the filter.
“
:
‚‰
■
The drain pump is blocked. Clean the drain pump.
■
The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
“
:
ƒ„
There is water in the base plate, the appliance is leaking. Turn off the tap. Call the
after-sales service!
“
:
„ƒ
flashes alternately with
“Ÿš
at the end of the programme.
Not a fault – the unbalanced load detection system has interrupted the spin cycle
because the laundry is unevenly distributed.
Distribute small and large items of washing in the drum. If required, spin the laundry
once more.
E
The childproof lock is activated – deactivate it.
Å
lights up
Too much foam has been detected and an additional wash cycle has been acti-
vated. Add less detergent to the next washing cycle with the same load.
The
Û
indicator light
for the Drum Clean
programme* flashes
Run the
Drum Clean
programme* or a
60 °C
programme to clean and care for the
drum and the outer tub.
Notes
■
Run the programme without laundry.
■
Use washing powder or a detergent containing bleach. To prevent foaming,
only use half the amount of detergent recommended by the detergent manufac-
turer. Do not use detergents designed for woollens or delicates.
■
Switching the information signal on/off
Other displays
Switch off the appliance, wait for five seconds and then switch it on again. If the dis-
play appears again, call the after-sales service.
* depending on the model
Summary of Contents for WAN series
Page 1: ...en Instruction Manual and Installation Instructions Washing machine WAN ...
Page 42: ...6 ...
Page 43: ...6 ...