Bosch VJD-8000, Installation Manual

Page: 5 / 28

Safety
Electric shock hazard
– Never attempt to connect the unit to any power network other than the type for which it
is intended.
– Use only the power supply unit that is included.
– Connect the unit to an earthed mains socket-outlet.
– Never open the housing.
– Never open the housing of the power supply unit.
– If a fault occurs, disconnect the power supply unit from the power supply and from all
other units.
– Install the power supply and the unit only in a dry, weather-protected location.
– If safe operation of the unit cannot be ensured, remove it from service and secure it to
prevent unauthorized operation. In such cases, have the unit checked by Bosch Security
Systems.
Safe operation is no longer possible in the following cases:
–
if there is visible damage to the unit or power cables,
– if the unit no longer operates correctly,
– if the unit has been exposed to rain or moisture,
– if foreign bodies have penetrated the unit,
– after long storage under adverse conditions, or
– after exposure to extreme stress in transit.
Installation and operation
– The relevant electrical engineering regulations and guidelines must be complied with at
all times during installation.
– Relevant knowledge of network technology is required to install the unit.
– Before installing or operating the unit, make sure you have read and understood the
documentation for the other equipment connected to it, such as monitors. The
documentation contains important safety instructions and information about permitted
uses.
– Perform only the installation and operation steps described in this manual. Any other
actions may lead to personal injury, damage to property or damage to the equipment.
Maintenance and repair
– Never open the housing of the unit. The unit does not contain any user-serviceable parts.
– Never open the housing of the power supply unit. The power supply unit does not contain
any user-serviceable parts.
– Ensure that all maintenance or repair work is carried out only by qualified personnel
(electrical engineers or network technology specialists). In case of doubt, contact your
dealer's technical service center.
Firmware and software
– VIDEOJET decoder 8000 may only be operated with the installed firmware and software
products.
– It is not allowed to install additional firmware or software other than intended.
1
1.1
1.2
1.3
1.4
VIDEOJET decoder 8000 Safety | en 5
Bosch Security Systems B.V. Installation Manual 2015.08 | V1 | DOC