18
| English
1 609 92A 3LG | (24.3.17)
Bosch Power Tools
Assembly
Inserting/Replacing the Batteries
Alkali-manganese batteries are recommended for the measuring tool.
To open the battery lid
9
, press on the latch
8
and remove the battery lid. Insert the
batteries. When inserting, pay attention to the correct polarity according to the rep-
resentation on the inside of the battery compartment.
If the batteries are running down, the battery warning
4
lights up red.
Always replace all batteries at the same time. Only use batteries from one brand and
with the identical capacity.
Remove the batteries from the measuring tool when not using it for extended
periods.
When storing for extended periods, the batteries can corrode and self-
discharge.
Operation
Initial Operation
Protect the measuring tool against moisture and direct sun light.
Do not subject the measuring tool to extreme temperatures or variations in
temperature.
As an example, do not leave it in vehicles for a long time. In case of
large variations in temperature, allow the measuring tool to adjust to the ambient
temperature before putting it into operation. In case of extreme temperatures or
variations in temperature, the accuracy of the measuring tool can be impaired.
Avoid heavy impact to or falling down of the measuring tool.
Damage to the
measuring tool can impair its accuracy. After heavy impact or shock, compare the
laser lines or plumb beams with a known horizontal or vertical reference line or
with already checked plumb points.
Switch the measuring tool off during transport.
When switching off, the level-
ling unit is locked. Else it can be damaged in case of intense movement.
Switching On and Off
To
switch on
the measuring tool, slide the On/Off switch
2
to the
“On”
position.
Immediately after switching on, the measuring tool sends laser beams out of the exit
openings
1
.
Do not point the laser beam at persons or animals and do not look into the
laser beam yourself, not even from a large distance.
OBJ_BUCH-3036-001.book Page 18 Friday, March 24, 2017 9:58 AM
