Bosch UML-323-90, User Manual

Page: 24 / 41

24 en | Installing the Monitor Bosch High Performance HD LED Monitors
F.01U.134.499 | 2.0 | 2012.10 User's Manual Bosch Security Systems, Inc.
5.8.3 VGA Connection
You can connect PC signal to the monitor using the VGA connector on the rear panel and a
VGA cable (D-SUB to D-SUB).
Figure 5.7 VGA Input
5.9 Connecting an Alarm Trigger
The monitor contains an alarm Trigger Input and a Trigger cable. These components allow you
to connect an alarm relay from a device, such as a camera or a door. Connect the two flying
leads from the Trigger cable into the relay out ports of the device. Then, route the other end
of the cable to the Trigger Input connector of the monitor. The following illustration depicts a
typical alarm relay configuration.
Figure 5.8 Camera to Monitor Relay
In the above example, the flying leads of the Trigger cable are connected to Trigger output
three and four of a Dinion camera. The cable is routed to the back panel of the UML monitor
and the plug-end of the wire is connected to the Trigger Input port. Refer to
Section 6.7 Setting Menu, page 31 , for configuring alarm acknowledgement.
Pin Description Pin Description Pin Description
1 Red Video 6 Red Ground 11 Ground
2 Green Video 7 Green Ground 12 SDA (for DDC)
3 Blue Video 8 Blue Ground 13 H-Sync or H+V Sync
4 Ground 9 N/A 14 V-Sync
5 Ground 10 Signal Cable Detect 15 SCL (for DDC)
Number Description
1 Dinion Camera
2 Flying Leads Connected to Trigger Outputs3 and 4
3 UML Back Panel