6 720 646 951 (2015/04)
Tronic 6000C
Explanation of symbols and safety instructions | 3
1.2
IMPORTANT SAFETY INSTRUCTIONS
When using this electrical equipment, basic safety precautions
should always be followed, including the following:
▶
READ AND FOLLOW ALL INSTRUCTIONS.
▶ This appliance must be grounded.
▶ Disconnect this product from the electrical supply before
cleaning, servicing or removing the cover.
▶ To reduce the risk of injury, close supervision is necessary
when the product is used near children or elderly persons.
▶ Warning: Mount the unit onto a flat section of wall, well
away from any potential splashes of water or spray and
away from areas where direct moist or wet contact could
occur.
▶ Warning: Indoor installation only, where it will NOT be
exposed to freezing.
▶ Warning: Do not install a check valve or any other type of
back flow preventer within ten feet of the cold water inlet.
▶ The electrical installation must conform to current National
Electrical Codes.
▶ Warning: Do not switch the heater on if you suspect that it
may be frozen. Wait until you are sure that it has completely
thawed out.
▶ The Tronic 6000C is designed to heat potable cold water
for domestic purposes. The heater is not designed to
accept inlet water temperatures above 86° F. The water
heater is not designed for preheated water or recirculation
applications. Contact Bosch Thermotechnology Corp.
before specifying or installing the appliance in any other
application.
IMPORTANT SAFETY INSTRUCTIONS
▶ ADDITIONAL CANADIAN SAFETY INSTRUCTIONS:
– As per the Canadian Electrical Code, C22.1-02 Section
26-744, an auxiliary terminal block must be fitted to
the unit before connecting to the electrical supply (Kit
Part N° “AE Canada Kit”).
(
See Fig. 9 and Fig. 10).
– A green terminal (or a wire connector marked “G,”
“GR,” “GROUND” or “GROUNDING”) is provided within
the control. To reduce the risk of electrical shock,
connect this terminal or connector to the grounding
terminal of the electrical service of supply panel with a
continuous copper wire in accordance with the
Canadian Electrical Code, Part I.
– This product shall be protected by a Class A ground
fault circuit interrupter.
SAVE THESE INSTRUCTIONS
▶ Keep this manual in a safe place once the unit has been
installed as it may be needed for future reference.
Safety of electrical appliances for domestic use and similar
purposes
Product installation and use must be in accordance with EN
60335-1 in order to prevent hazards from occurring when
using electrical appliances.
