Bosch TIS3.1 Series, Instruction Manual

Page: 15 / 164

Settings
en
15
1
Settings
Settings
This appliance has different factory
settings. You can customise the settings
on the appliance.
Note: If no button is pressed within
90 seconds, the appliance switches to
"Choose beverage" without saving. The
previous setting remains unchanged.
You can select the following settings:
Automatic switch-off
Selecting automatic switch-off
The appliance switches off
automatically at a specific time after the
last button was pressed. This time can
be selected, with settings from
15 minutes to 4 hours possible here.
1.
Press and hold
%
and
Calc’nClean for at least 3 seconds.
2.
Touch Caffe Crema button and
"Automatic switch-off" will be
activated.
3.
Touch
%
button and select the
required time.
The following settings are possible:
4.
Touch
Caffe Crema
button to save
the setting.
5.
Touch
Calc’nClean
button to exit the
menu.
Switching the audible signal
on/off
Whenever a button is pressed, an
audible signal sounds.
This can be switched on or off.
1.
Press and hold
%
and
Calc’nClean
for at least 3 seconds.
2.
Touch
Cappuccino
button, and
"Signal tone" menu will be activated.
3.
Touch
%
button and switch
signal tone on or off.
4.
Touch
Cappuccino
button to save
the setting.
5.
Touch
Calc’nClean
button to exit the
menu.
Setting the water hardness
It is important to set the water hardness
correctly so that the appliance indicates
in good time when the descaling
programme should be run. The preset
water hardness is level 4.
You can check the water hardness
using the enclosed test strip or by
asking your local water supplier.
1.
Briefly immerse the enclosed test
strip in fresh tap water, leave it to
drip and read off the result after 1
minute.
2.
Simultaneously hold down
%
and
Calc’nClean
for at least
3 seconds.
3.
Touch
Espresso
button, and "W.
hardness" menu will be activated.
15 minutes
30 minutes (factory setting)
1 hour
2 hours
4 hours
On (factory setting)
Off