Bosch TES 556, Instruction Manual

Page: 36 / 56

32
en
The filter is no longer effective when the
Change filter! display appears, or at the
latest after 2 months. It needs to be re-
placed for reasons of hygiene and so that
there is no build-up of limescale (this could
damage the appliance). Replacement filters
can be obtained from retailers or from cus-
tomer service (see “Accessories”). If no new
filter is used, turn the
filter
setting to
No / Old
.
Note:
You can use the filter indicator to
mark the month in which you inserted the
filter. You can also mark the month in which
you will need to replace the filter next (at
the latest after two months).
Note: If the appliance has not been used
for a prolonged period (e.g. vacation) the
filter should be rinsed before the appliance
is used again. To do so, dispense a cup of
hot water and pour it away.
Menu settings
You can adapt the appliance to your indi-
vidual needs in the menu settings.
1. Hold the
e
off /
j
button (13) down for
at least 3 seconds.
2. Press the
e
off /
j
button (13) repeated-
ly until the required menu item appears
in the display.
3. Select the required setting with the
upper rotary knob (15).
4. Confirm by pressing the start
button (10).
To leave the menu without making any
changes, turn the rotary selector to
Exit
and
press the
start
button (10).
You can set the following:
Shut off : Here you can set the time
span after which the appliance automati-
cally switches off following the last drink
preparation. A time between 15 minutes and
4 hours can be set. To save power you can
specify a shorter period.
Filter
: Here you can set whether a water
filter is being used. If a water filter is not be-
ing used, turn the setting to No / Old . If a
water filter is being used, turn the setting to
Activate filter
. New water filters have to
be rinsed before use (see “Water filter”).
Start Calc’nClean : The service pro-
grammes ( Calc’nClean / descaling /
cleaning
) can be selected manually
here. Press the start button (10) and run
the selected programme (see “ Service
Programmes”).
Temp.
: The brewing temperature (
high
/
middle
/
low
) can be set here.
Language : The display language can be
set here.
Water hardness
: The water hardness
setting can be adjusted on this appliance.
It is important to set the water hardness
correctly, so that the appliance indicates
accurately when the descaling programme
should be run. The factory setting for the
water hardness is 4.
You can check the water hardness using
the enclosed test strip or by asking your
local water supplier.