29
04/2012
en
5.
Place a container with a capacity of at
least 500 ml under the drink outlet.
6.
Open the brewing unit by lifting the
handle (4a) and then pushing the
brewing unit up. Place the Service
T DISC on the T DISC holder (4b) with
the barcode facing down. Make sure
that the fl ap of the T DISC is located in
the slot in the front.
►
Close the brewing unit by fi rst bringing it
down and then pushing the handle (4a)
fi rmly to the machine, until you hear an
audible click.
7.
Press and hold the Start / Stop button
(2) for
atleast5seconds
to start the
descaling programme.
►
Release the Start / Stop button after
5 seconds; the machine will run the
descaling cycle automatically. This is
indicated by the Status LED
F
and
“Descale required” LED
'
blinking.
¡
i
Note:
The descaling solution is pumped through
the machine in intervals and then runs into
the container until the water tank is almost
empty. A small amount of liquid is always
left in the tank.
!
Important:
The descaling programme runs for
about
20minutes
.
8.
When the Status LED
F
and “Descale
required” LED
'
stop blinking, the
descaling process is complete. Empty
the receiving container and return it
under the drink outlet.
►
Rinse the water tank thoroughly and fi ll
up to the
max
mark with fresh water.
►
Replace it back onto your TASSIMO
machine.
5.
6.
500 ml
20 min
7.
5 sec.
8.
06_TAS55_Korea.indb 29
02.05.2012 12:20:42
