en
15
Switching off the appliance
Short time after the end of the programme:
–
Open the door.
–
Switch off the main switch
(
.
–
Turn off the tap (not applicable if Aqua-
Stop fitted).
–
Remove the utensils when they have
cooled down.
ã=
Warning
At the end of the programme please open
the door fully and not partially
when emptying the dishwasher. Any
escaping water vapour could damage
sensitive worktops.
Interrupting the programme
–
Open the door.
–
Switch off the main switch
(
.
The LEDs go out. The programme
is saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave
the door ajar for several minutes
and then close. Otherwise, expansion
(pressure) may cause the appliance
door to spring open or water to run
out of the appliance.
–
To continue the programme,
switch on the main switch
(
again.
–
Close the door.
Terminating the programme
(Reset)
–
Open the door.
–
Simultaneously press programme
buttons
#
and
3
for approx. 3 sec.
–
Close the door.
The programme sequence lasts
approx. 1 min.
–
Programme end display
@
is lit.
–
Open the door.
–
Switch off the main switch
(
.
–
Close the door.
Changing the programme
After you have switched the appliance on,
it is possible to change the programme
within 2 min.
If you want to change the programme
afterwards, the appliance waits until
the initiated programme section
(e. g. washing) ends.
Downloaded from DishWasher-Manual.com Manuals
