Installation and connection
en
37
Setting hot water:
1.
Close the door.
2.
Switch on ON/OFF switch
(
.
3.
Hold down programme button
#
and press START button
P
until
•
:
‹
... is indicated on the digital
display.
4.
Release both buttons.
The LED for button
#
flashes and
the digital display
)"
displays the
factory setting
•
:
‹…
.
5.
Press programme button
#
until
the factory set value
‘
:
‹‹
is indicated on the digital
display
)"
.
To change the setting:
1.
By pressing the
3
button, you can
switch the hot water setting off
‘
:
‹‹
or on
‘
:
‹‚
.
2.
Press START button
P
.
The set value is saved.
Electrical connection
ヽ
Connect the appliance to an
alternating current only, ranging from
220 V to 240 V and 50 Hz or 60 Hz
via a correctly installed socket with
protective earth conductor. See
rating plate for required fusing
92
.
ヽ
The socket must be near
the appliance and freely accessible
following installation.
If the plug is not freely accessible, an
allpole disconnector with a contact
opening of at least 3 mm must be
fitted on the installation side
to satisfy the relevant safety
instructions.
ヽ
The connection may be modified by
technicians only.
ヽ
A power cord extension may be
purchased from customer service
only.
ヽ
Use only a residual current operated
circuit-breaker which features
the symbol
‚
. Only this extension
guarantees compliance with
the currently valid regulations.
ヽ
The appliance features a water
damage protection system. Please
note the system will not function
unless
the power supply
is connected.
Removing the appliance
Also observe
the sequence of worksteps here.
1.
Disconnect the appliance from
the power supply.
2.
Turn off the water supply.
3.
Disconnect the waste water
and fresh water connections.
4.
Loosen fastening screws for the
furniture parts.
5.
If fitted, remove the base panel.
6.
Pull out the appliance, carefully
pulling the hose behind.
