en
Installation and connection
34
Fresh water connection
1.
Connect the fresh-water connection
to the tap according
to the installation instructions with
the enclosed parts.
Ensure that the fresh-water
connection is not kinked,
crushed or twisted.
2.
When replacing the appliance,
always use a new water supply hose.
Water pressure:
at least 0.05 MPa (0.5 bar), maximum
1 MPa (10 bar). At a higher water
pressure: connect pressure-reducing
valve ahead.
Inlet rate:
minimum 10 litres/minute
Water temperature:
Note printing on the water inlet hose!
If models are marked with 25°,
the water temperature may be max.
25 °C (cold water).
For all other models:
cold water preferred; hot water max.
temperature 60 °C.
Electrical connection
ヽ
Connect the appliance to an
alternating current only, ranging from
220 V to 240 V and 50 Hz or 60 Hz
via a correctly installed socket with
protective earth conductor. See
rating plate for required fusing
92
.
ヽ
The socket must be near
the appliance and freely accessible
following installation.
If the plug is not freely accessible, an
allpole disconnector with a contact
opening of at least 3 mm must be
fitted on the installation side
to satisfy the relevant safety
instructions.
ヽ
The connection may be modified by
technicians only.
ヽ
A power cord extension may be
purchased from customer service
only.
ヽ
Use only a residual current operated
circuit-breaker which features
the symbol
‚
. Only this extension
guarantees compliance with
the currently valid regulations.
ヽ
The appliance features a water
damage protection system. Please
note the system will not function
unless
the power supply
is connected.
Summary of Contents for SMV50C00GB
Page 1: ... JTIXBTIFS FO 0QFSBUJOH JOTUSVDUJPOT ...
Page 2: ...6WDUW 5HVHW VHF 3URJUDP 5HVHW VHF ...
Page 36: ......
