en
19
The majority of faults which could occur in
daily operation can be rectified by the
user. This ensures that the appliance is
quickly available for use again. The
following overview will help you locating
the causes and gives helpful advise to
eliminate them.
ã=
Warning
Don’t forget: Repairs may be carried out
by technicians only. If a component has to
be replaced, ensure that only original
spare parts are used. Improper repairs or
use of non-original spare parts may cause
considerable damage and put the user at
considerable risk.
... when the appliance is
switched on
The appliance does not start.
–
The mains fuse has tripped.
–
The appliance plug has not been
inserted.
–
The appliance door has not been shut
properly.
... on the appliance
Lower spray arm rotates sluggishly.
–
Spray arm blocked.
The door is difficult to open. *
–
Child-proof lock is activated. The
deactivation instructions are at the
back in the envelope.
* depending on model
Door cannot be closed.
–
Door lock has been activated. To reset,
close the door with greater force.
Cover on the detergent dispenser cannot
be closed.
–
Detergent dispenser overfilled or
mechanism blocked by sticky
detergent residue.
Detergent residue in the detergent
dispenser.
–
Dispenser was damp when filled.
“Check water supply” display
h
lights
up.
–
Tap turned off.
–
Water supply interrupted.
–
Supply hose kinked.
–
Filter in the water supply blocked.
–
Switch off the appliance and pull
out the mains plug.
–
Turn off the tap.
–
Clean filter in the supply hose.
–
Reconnect power supply.
–
Turn on the tap.
–
Switch on the appliance.
–
Water is left in the appliance at the end
of the programme.
–
Waste water hose is blocked or
kinked.
–
Waste water pump blocked, cover
on the waste water pump is not
locked in position
(see Maintenance and care).
–
Filters blocked.
–
The programme has not yet ended.
Wait until programme ends or
implement “Reset” function.
The “Check water supply” display
h
flashes rapidly.
–
Water in the safety system.
–
Switch off the appliance and pull
out the mains plug.
–
Turn off the tap.
–
Call customer service.
Refill indicator for salt
`
and/or rinse-
aid
X
is not lit.
–
Refill indicator/s switched off.
–
Adequate salt/rinse-aid available.
Troubleshooting
