Bosch SMI 63M05, Operating Instructions Manual

Page: 17 / 28

en
17
Interrupting the programme
– Switch off ON/OFF switch
(
.
The LEDs go out. The programme is
saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave the
door ajar for several minutes and then
close. Otherwise, expansion (pressure)
may cause the appliance door to
spring open or water to run out of the
appliance.
– To continue the programme, switch on
the ON/OFF switch
(
again.
Terminating the programme
(Reset)
– Press START button
P
for
approx. 3 sec.
The numerical display
)"
indicates
‹
:
‹‚
.
– The programme sequence lasts
approx. 1 min. On the digital
display
)"
is indicated
‹
:
‹‹
.
– Switch off ON/OFF switch
(
.
Changing the programme
When the START button
P
has been
pressed, the programme cannot be
changed.
The only way a programme can be
changed is by Cancel programme (Reset).
Intensive drying
The final rinse uses a higher temperature
which improves the drying result. The
running time may increase slightly.
(Caution if utensils are delicate!)
–
Close the door.
– Switch on ON/OFF switch
(
.
– Hold down programme button
#
and
press START button
P
until the
digital display
)" •
:
‹
... is indicated.
– Release both buttons.
The LED for button
#
flashes and the
digital display
)"
displays the factory
setting
•
:
‹…
.
– Press programme button
#
until the
factory set value
š
:
‹‹
is indicated on
the digital display
)"
.
To change the setting,
– Press the button
3
to switch the
Intensive drying on
š
:
‹‚
or off
š
:
‹‹
.
– Press START button
P
.
The set value is saved.