en
8
As soon as the rinse-aid refill indicator
P
is lit on the fascia, there is still a rinse-aid
reserve of 1 – 2 rinsing processes. Refill
with rinse aid.
The rinse aid is required for stain-free
utensils and clear glasses. Use only rinse
aid for domestic dishwashers.
Combined detergents with rinse-aid
component may be used up to a water
hardness of 21° dH (37° fH, 26° Clarke,
3.7 mmol/l) only. If the water hardness is
over 21° dH, rinse aid must be used.
–
Open the dispenser
1J
by pressing
and lifting the plate on the cover.
–
Carefully pour rinse aid up to the max.
mark in the filler opening.
–
Close cover until it clicks shut.
–
To prevent excessive foam formation
during the next rinse cycle, remove any
rinse aid which has run over with a
cloth.
Setting amount of rinse aid
The amount of rinse aid dispensed can be
set in 4 stages. Accordingly 0, 1, 2 or 3
displays are lit (see water hardness table).
Factory setting: 2.
Do not change the amount of rinse aid
unless streaks (select lower
setting) or water stains (select higher
setting) are left on the utensils.
–
Close the door.
–
Switch on ON/OFF switch
(
.
The Cleaning display
)"
flashes.
–
Press and hold down the START
button
8
.
–
Rotate programme selector
0
until
the rinse aid refill indicator
P
flashes.
–
Release button.
The rinse aid refill indicator
P
flashes
and the displays
h
and
`
are lit
(= Setting 2).
To change the setting:
–
Rotate programme selector
0
until
the required setting has been selected.
–
Press START button
8
.
The rinse-aid refill indicator
P
goes
out. The selected setting is saved.
Switching off rinse-aid refill
indicator
If the rinse-aid refill indicator
P
is
impaired (e.g. when using combined
detergents containing rinse-aid
component), it can be switched off.
–
Proceed as described under “Setting
amount of rinse aid” and select
setting 0.
The rinse aid refill indicator
P
is now
switched off.
Rinse aid
%
PD[
