17
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
1
Press the
[On/Off]
button.
2
Press the
[+]
button until the display jumps to “
h:01
”.
3
Press the
[+]
or
[-]
button until the displayed time corresponds with your requirements.
h:01
= 1 hour delay
h:24
= 24 hour delay
4
Press
[Start]
to activate delay start.
To cancel delay start:
1
Press the
[+]
or
[-]
button until
“h:00”
is indicated on the digital display.
2
Press and hold
[Start]
for 3 seconds to cancel the cycle. You may now start a new cycle.
Cycle Completion Signal
1
Open the door and press the
[On/Off]
button.
2
Hold down the “
A
” button (see page 15) and press
[Start]
until the display indicates “
d:00
”.
Release both buttons.
3
Press the “
A
” button until the display shows “
b:02
”.
4
Press the “
C
” button to increase or decrease the tone “
b:00
” = OFF and “
b:03
” = LOUDEST and press
[Start]
to save setting and close the door.
Infolight®
An LED illuminates the floor to indicate the unit is running. If the appliance is installed at eye-level, the
LED is not visible.
To change the setting:
1
Open the door and press the
[On/Off]
button.
2
Hold down the “
A
” button (see page 15) and press
[Start]
until the display indicates “
d:00
”.
3
Release both buttons.
4
Press the “
A
” button until the display shows “
1:01
”.
5
Press the “
C
” button to switch between “
1:01
” = ON and “
1:00
” = OFF and press
[Start]
to save.