en-us
Getting Started
14
Note:
If the appliance was
disconnected from the power supply
for a prolonged period, the time
starts at 12:00 o’clock. Set the time.
Switching on the appliance
for the first time
When the dishwasher is switched on
for the first time, you are taken
directly to the settings for switching
on the appliance for the first time.
The following text is indicated on the
display window at the top
@
:
Scroll with < >
Set with
+ -
Leave with Setup 3 sec.
The required settings for switching on
the appliance for the first time are
listed in the table below.
Change the setting as follows:
1.
Keep pressing button
>
`
until
the required setting is displayed.
2.
Make the selection with setting
buttons
+ -
X
.
3.
Press and hold the Info button
8
for 3 seconds.
The selected setting has now been
stored.
Settings
The dishwasher has been preset with
certain settings for your convenience.
You can change these factory
settings.
Change the setting as follows:
1.
Open the door.
2.
Switch on On/Off switch
(
.
3.
Press Info button
8
for
3 seconds until the following text
is indicated on the display window
at the top
@
:
Scroll with < >
Set with - +
Leave with Setup 3 sec.
4.
Keep pressing button
>
`
until
the required setting is displayed.
5.
Make the selection with setting
buttons
+ -
X
.
6.
Press and hold the Info button
8
for 3 seconds.
The chosen setting has now been
stored.
You have the option of resetting all
changed settings back to the original
factory settings.
Note:
When you reset your
dishwasher to the factory settings,
you are taken directly to the settings
for switching on the dishwasher for
the first time.
Settings
Switching on the appli-
ance for the first time
Factory setting
Infotext
by pressing Info button
Language
American English
Language selection.
Time format
12h
12h or 24h.
Time setting
12:00
Set the current time.
Water hardness
°E0-8 Soft
Setting water hardness. When using Multitabs,
select the lowest setting.
Rinse aid dispenser
Level 5
Amount of rinse aid affects drying. When using
Multitabs, select setting 0.
