en-us
Operating the Dishwasher
30
Switching the appliance on
1.
Turn the water supply on fully.
2.
Press the
On/Off
button
(
.
The AUTO wash cycle has been
preset as a default whenever the
appliance starts. This wash cycle
remains selected if no other wash
cycle button
0
is pressed.
Select any desired option.
3.
Press
Start
button
P
.
Wash cycle sequence starts.
Note:
Your dishwasher is protected
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Close the appliance door
and press the Start button
P
again.
Time display
When a wash cycle is selected the
remaining wash cycle time is shown
on the display
8
.
The wash cycle time is determined
during the wash cycle by the water
temperature, the amount of dishes,
as well as the degree of soiling and
may vary (depending on the selected
wash cycle).
Delay start
You can delay the start of the cycle in
one hour increments up to 24 hours.
To set Delay start:
1.
Press
On/Off
button
(
. Select a
cycle.
2.
Press
Delay
button
@
until the
displayed time corresponds with
your requirements.
3.
Press
Start
button
P
to activate
Delay start.
To cancel Delay start:
1.
Press
Delay
button
@
until
œ
:
‹‹
is indicated on the digital
display
8
.
2.
Press
Start
button
P
to save
setting.
Note:
Your dishwasher is protected
against unintentional operation. If the
appliance door remains open for
more than 4 seconds after pressing
the Start button, the operation will be
paused. Close the appliance door
and press the Start button
P
again.
Wash cycle end
The wash cycle has ended when the
display
8
reads
‹
:
‹‹
.
If the signal tone has been set, the
wash cylce end is also indicated by a
buzzer.
To change the signal volume:
1.
Press the
On/Off
button
(
.
2.
Hold down the function key
#
and press the
Start
button
P
until the display
8
indicates
š
:
‹
x (x can be any number).
Release both buttons.
3.
Press the function key
#
until
the display shows
›
:
‹ƒ
.
4.
Press the function key
3
. Each
time the button is pressed the set
value increases by one level;
when it reaches the value
›
:
‹„
,
the display jumps back to
›
:
‹‹
(off).
5.
Press the
Start
button
P
to
save the setting.
œ
:
‹‚
1 hour delay
œ
:
ƒ…
24 hours delay
›
:
‹‹
Off
›
:
‹‚
low
›
:
‹ƒ
medium
›
:
‹„
loud