2.3
Electrical connection
Install according to national and local codes.
Carefully place dishwasher on its back to make electrical
connections to the terminal block. Turn power off at the fuse box.
Extend power cord approximately 21” from the left side of the
opening, and 30” from the back wall, making sure the cord
doesn’t contact any moving parts.
Strip outer casing of electrical wire to expose 2.5" - 3" (65 - 76
mm) of inner wires, then strip 1/2" (13 mm) casing from each
wire. If plugging the dishwasher into an outlet, contact customer
service to order power cord accessory kit (
SGZPC001UC
). Insert
cord through a strain relief (not included) and install to strain relief
plate. Attach wires to terminal block (black –
L
(hot), white –
N
(neutral) & green –
G
(ground). Unscrew terminal screws,
but
don’t loosen or remove them as they may become damaged
.
Attach wires snugly,
but don’t overtighten
.
2.4
Water connection
Install according to national and local codes.
Carefully place dishwasher on its back to make water
connections to the water inlet valve. Use a 90º elbow fitting with
Teflon tape as needed. Don’t overtighten.
Attach the hot water line to the 90° elbow and route it underneath
the unit toward the hot water connection. Make sure the line
doesn’t contact any moving parts.
702_58300000148618_ara_en_a
Page 4 of 42
