en
25
Fresh water connection
–
Connect the fresh-water connection to
the tap according to the installation
instructions with the enclosed parts.
Ensure that the fresh-water connection
is not kinked, crushed or twisted.
–
When replacing the appliance, always
use a new water supply hose.
Water pressure:
at least 0.05 MPa (0.5 bar), maximum
1 MPa (10 bar). At a higher water
pressure: connect pressure-reducing valve
ahead.
Inlet rate:
minimum 10 litres/minute
Water temperature:
cold water preferred; hot water max.
temperature 60 °C.
Electrical connection
–
Connect the appliance only to 230 V
and 50 Hz alternating current via
a correctly installed socket with
protective conductor. See rating plate
for required fusing
9:
.
–
The socket must be near the appliance
and freely accessible following
installation.
–
The connection may be modified by
technicians only.
–
A power cord extension may be
purchased from customer service only.
–
Use only a residual current operated
circuit-breaker which features
the symbol
‚
. Only this extension
guarantees compliance with
the currently valid regulations.
Removing the appliance
Also observe the sequence of worksteps
here.
–
Disconnect the appliance from
the power supply.
–
Turn off the water supply.
–
Disconnect the waste water and fresh
water connections.
–
Loosen fastening screws for the
furniture parts.
–
If fitted, remove the base panel.
–
Pull out the appliance, carefully pulling
the hose behind.
Transportation
Empty the dishwasher and secure loose
parts.
Drain the appliance according
to the following steps:
–
Turn on the tap.
–
Close the door.
–
Switch on the main switch
(
.
–
Select programme
+
.
The expected programme duration
is indicated on the numerical display
8
. Programme sequence starts.
–
After approx. 4 minutes
End the programme by simultaneously
pressing buttons
#
and
3
.
–
After approx. 1 minute
The numerical display indicates
‹
.
–
Switch off main switch
(
and turn off
the tap.
Transport appliance upright only.
(This prevents residual water from running
into the machine control and damaging
the programme sequence.)
Protection against frost
Protection against frost (Emptying the appliance)
If the appliance is in a room where there is
a risk of frost (e.g. holiday home), empty
the appliance completely (see
Transportation).
Summary of Contents for SGS 45N68
Page 1: ... JTIXBTIFS FO 0QFSBUJOH JOTUSVDUJPOT ...
Page 2: ......
