16
Setting the Amount of Rinse Aid
The amount of rinse aid dispensed can be set from “r:00” to “r:06”.
To change the setting:
1
Press the
[On/Off]
button.
2
Hold down the “
A
” button (see page 15) and press
[Start/Resume]
until the display indicates
“
H:0x
”
(x can be any number).
3
Release both buttons.
4
Press the “
A
” button until the display shows “
r:05
”.
5
Press the “
C
” button to select the desired setting.
“
r:00
” = dispenser is OFF
“
r:01
” = lowest setting
“
r:02
” = low setting
“
r:03
” = medium setting
“
r:04
” = medium/high setting
“
r:05
” = high setting
“
r:06
” = highest setting
6
Press
[Start/Resume]
to save the setting.
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
1
Press the
[On/Off]
button.
2
Press the
[+]
button until the display jumps to “
h:01
”.
3
Press the
[+]
or
[-]
button until the displayed time corresponds with your requirements.
h:01
= 1 hour delay
h:24
= 24 hour delay
4
Press
[Start/Resume]
to activate delay start.
To cancel delay start:
1
Press the
[+]
or
[-]
button until
“h:00”
is indicated on the digital display.
2
Press and hold
[Start/Resume]
for 3 seconds to cancel the cycle. You may now start a new cycle.
NOTE: Your dishwasher is protected against unintentional operation. If the appliance door remains open for more than
4 seconds after pressing the [Start/Resume] button, the operation will be paused. Press the [Start/Resume] button
again and close the appliance door.
