19
BOSCH
* Model dependent
EN
gl
ISH
5.2. Automatic clean warning
Pilot light (12*) will flash indicating that boiler
must be rinsed.
1
Check carefully that the appliance is cold and
unplugged for more than 2 hours, and that the
water tank (1) is empty.
2
Model dependent:
Fix the iron to the stand
by inserting the tip of the iron into the front slot
and moving the fixation lever (14*) against the
heel of the iron.
3
Place your appliance over a sink or bucket.
4
Lean the appliance on the opposite side of the
filter opening.
5
Unscrew the filter (4*) and take it out.
6
Model dependent:
To wash the scale collector,
place it under the water tap and wash it up until calc
residues are removed. Squeeze it as indicated in the
picture a).
To obtain the best result, you may immerse the scale
collector for approximately 30 minutes in tap water
(250 ml) mixed with a measure (25 ml) of descaling
fluid, as indicated in the picture b). Then, rinse it
again with water (very important!).
The descaling fluid can be obtained from our
After-sales service or from our website.
Accessory code
(After-sales)
Name of accessory
(Online shop)
00311715
TDZ1101
7
Holding your steam generator in the lateral
position and using a jug, fill the boiler with 1/4
litre of water and replace the filter.
8
Shake the base unit for a few moments,
unscrew the filter again and empty the boiler
completely over a sink or bucket.
For best results, we recommend that this
operation is performed twice.
Important:
before re-closing, make sure no
water remains in the boiler.
9
Replace and tighten up the filter.
Model dependent:
To reset the “Calc'n'Clean” counter, switch
the steam station off twice, keeping it off for
at least 30 seconds each time.
(on → 30s off → on → 30s off → on)
Auto shut-off *
If during ironing, the steam release button
(17-18*) on the iron handle is not pressed for a
certain length of time (8 minutes), the steam
station will automatically switch off.
The “auto shut-off” pilot lamp (9) will flash when
auto shut-off has been activated.
To switch the steam station back on, press the
steam release button again.
TextileProtect
4. Fabric protection soleplate
cover *
See the leaflet sides
The fabric-protection soleplate cover (21*) is
used for steam-ironing delicate garments at
maximum temperature without damaging them.
Use of the soleplate cover also does away with
the need for a cloth to prevent shine on dark
materials.
It is advisable to first iron a small section on the
inside of the garment to see if it is suitable.
To attach the soleplate cover to the iron, place
the tip of the iron into the end of the soleplate
cover and pull the elastic strap over the lower
rear of the iron until it fits tightly. To release the
soleplate cover, pull the elastic strap and remove
the iron.
The fabric-protection soleplate cover may be
purchased from our customer service or from our
website.
Accessory code
(After-sales)
Name of accessory
(Online shop)
00571510
TDZ2045
5. Calc'n'Clean Advanced
See the leaflet sides
5.1. Cleaning the Boiler
To extend the life of your steam generator and to
prevent any build up of scale, it is essential that
you rinse out the filter (4*) and the boiler after
several hours of use. If the water is hard,
increase the frequency.
Do not use descaling agents for rinsing out the
boiler, as they could damage it.
