English |
5
Bosch Power Tools
F 016 L81 157 | (30.9.14)
– 1.0 mm
2
: max. length 40 m
– 1.5 mm
2
: max. length 60 m
– 2.5 mm
2
: max. length 100 m
Note: If an extension cable is used it
must be earthed and connected
through the plug to the earth cable of
your supply network in accordance
with prescribed safety regulations.
If in doubt contact a qualified electri-
cian or the nearest Bosch Service Cen-
tre.
WARNING! Inadequate extension
cables can be dangerous. Exten-
sion cable, plug and socket must
be of watertight construction and
intended for outdoor use.
Cable connections should be kept dry
and off the ground.
It is recommended for increased elec-
trical safety to use a Residual Current
Device (RCD) with a tripping current of
not more than 30 mA. Always check
your RCD every time you use it.
For products
not sold in GB
:
WARNING:
For your safety, it is re-
quired that the plug attached to the ma-
chine is connected with the extension
cord. The coupling of the extension
cord must be protected against splash
water, be made of rubber or coated
with rubber. The extension cord must
be used with a cable strain relief.
The connection lead must be inspected
for signs of damage at regular intervals
and may only be used if in perfect con-
dition.
If the supply cord is damaged, it must
be replaced by a Bosch Service Centre.
Products sold in GB only
: Your prod-
uct is fitted with a BS 1363/A approved
electric plug with internal fuse (ASTA
approved to BS 1362).
If the plug is not suitable for your socket
outlets, it should be cut off and an ap-
propriate plug fitted in its place by an
authorised customer service agent.
The replacement plug should have the
same fuse rating as the original plug.
The severed plug must be disposed of
to avoid a possible shock hazard and
should never be inserted into a mains
socket elsewhere.
Products sold in AUS and NZ only
:
Use a residual current device (RCD)
with a rated residual current of 30 mA
or less.
Maintenance
Always wear gardening gloves
when handling or working near
the sharp blades.
Keep all nuts, bolts and screws tight
to be sure that the machine is in safe
working condition.
Check the grass catcher frequently
for wear or deterioration.
Examine the machine and replace
worn or damaged parts for safety.
Ensure replacement cutting means
of the right type are used.
Ensure replacement parts fitted are
Bosch approved.
Before storage ensure machine is
clean and free from debries, if nec-
essary clean with a soft, dry brush.
OBJ_BUCH-2011-004.book Page 5 Tuesday, September 30, 2014 8:26 AM
