-10-
VARIABLE SPEED CONTROLLED
TRIGGER SWITCH
Your tool is equipped with a variable speed
trigger switch. The tool can be turned "ON" or
"OFF" by squeezing or releasing the trigger.
The speed can be adjusted from the minimum
to maximum nameplate RPM by the pressure
you apply to the trigger. Apply more pressure
to increase the speed and release pressure to
decrease speed Fig. 1).
To reduce the risk of
injury
immediately
discontinue use of the tool if the variable
speed control ceases to function.
Subsequent loss of on/off control of the trigger
switch is likely.
FORWARD/REVERSING LEVER &
TRIGGER LOCK
Your tool is equipped with a forward/
reversing lever and trigger lock located above
the trigger (Fig. 9). This lever was designed for
changing rotation of the chuck, and for locking
the trigger in an “OFF” position to help prevent
accidental starts and accidental battery
discharge.
For forward rotation, (with chuck pointed away
from you) move the lever to the far left. For
reverse rotation move the lever to the far right.
To activate trigger lock move lever to the
center off position.
Do not change direction
of rotation until the tool
comes to a complete stop.
Shifting during
rotation of the chuck can cause damage to the
tool.
Operating Instructions
MODE SELECTOR DIAL
The mode selector dial allows the tool to be
set for various applications as listed in the
following chart, (Fig. 10).
Do not operate the
selection dial until the
tool comes to a complete stop.
Shifting during
rotation of the chuck can cause damage to the
tool.
When using demolition or chipping bits such
as bull points, chisels, spades, gouges, etc.
the “Hammer Only” mode must be selected.
Drilling only: Drilling/hammering: Vario-lock Hammering only:
used for drilling
used for drilling allows for desired used for light
wood, steel, etc. concrete positions of “hammer” chipping work
FIG. 10
FIG. 9
FORWARD/REVERSING LEVER
AND TRIGGER LOCK
2610047991_RH328VC-36 10/4/17 8:38 AM Page 10
