3 609 929 408/2.1 | LTH
Electric Drives and Controls
| Bosch Rexroth AG
33/60
1 Safety Instructions
1
Safety Instructions
1.1
General
Read this Technical Information Manual before operating this equipment.
Keep this Technical Information Manual in a place which is accessible to all users at all times.
1.2
Instructions for Correct Usage
The Technical Information Manual contains instructions for the proper use of the equipment.
The products were developed, produced, tested and documented in compliance with the applicable safe-
ty standards. When the handling instructions and safety instructions described for planning, installation
and operation are observed, the product normally does not represent any danger for persons or objects.
1.3
Qualified Personnel
This Technical Information Manual is intended for specially trained technicians and engineers who have
specific knowledge with respect to the hardware components of the equipment.
Unless described in this documentation, the intervention in the hardware or software of our products may
be performed only by our experts.
The unqualified intervention in the hardware or software or non-observation of the warning notices which
are contained in this document or attached to the product could lead to serious injuries or damage.
Qualified personnel are persons who:
– as
project personnel
, are familiar with the safety regulations of electrical and automation technology,
– as
operating personnel
, have been instructed in the handling of the equipment and are aware of the
contents of this manual with respect to its operation,
– as
installation personnel
, are authorized to place into operation, ground and mark electrical circuits
and equipment /systems according to the technical safety standards.
1.4
Safety Warnings in this Technical Information
The following symbols are used in this Technical Information Manual:
DANGER:
This symbol is used when
death
,
serious injury
or considerable
damage
could occur un-
less the appropriate precautions have been observed.
The five safety rules must be applied under all circumstances:
– Disconnect power
– Secure against power being reapplied
– Check for absence of voltage
– Ground and short-circuit as required
– Cover or shield adjacent live parts
– Warning of dangers caused by batteries!
WARNING:
This symbol is used when inexact observation or disregard of the instructions can lead to
injuries
.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com