42/72
Installation
Bosch Rexroth AB
, RE 15300-WA, Version 06.2021
Mounting the coupling adapter to the driven shaft
1.
Mount 3 lifting eyes on the coupling adapter for lifting, see
in chapter
6.1.2: Lifting motors and accessories
2.
Mount the M30 to M20 adapter in customer shaft if needed.
3.
Align the coupling adapter with the driven shaft.
4.
Pass the assembly tool through the centre of the coupling adapter and screw it
into the driven shaft by using the squared key in the end of the tool, see
5.
Pull the coupling adapter on the shaft by turning the nut on the assembly tool
t
o specified clamping length (length B, see
6.
Tighten the shrink disc, (see
: Tightening of shrink disc page 44
).
7.
Remove the assembly tool.
8.
Remove the lifting device and the lifting eyes from the coupling adapter.
Fig. 41: Mounting the coupling adapter on the driven shaft with the assembly tool.
Assembly tool
1
Nut
2
Carriage beam
Driven shaft
1
Coupling adapter
2
DD00058276, DD00080049