RE 29696-01-B/2021-06-15, Bosch Rexroth AG
Installation |
4THE5 17
/24
7�3�3 Installation
1�
Insert the joystick in the console/armrest with care to prevent damage on the
wiring or protection boot.
2�
Fasten the joystick using the specified mounting bolt, required tightening
torque written on installation drawing (maximum tightening torque 10 Nm).
3�
Place the boot in its correct position under the fixation plate for an optimal
protection. Note that this boot has no pannel IP relevance.
4�
Connect the product with caution regarding the pin-out written on the
installation drawing.
7�3�4 Notice on wiring and circuitry
• Lines from the joystick to the electronics must not be routed close to other
power-conducting lines in the machine.
• The wiring harness should be mechanically secured in the area in which the
joystick is installed.
• If possible, lines should be routed in the machine interior. If the lines are routed
outside of the machine, their secure mounting is to be ensured.
• Lines must not be kinked or twisted, must not rub against edges and must not be
routed through sharp-edged ducts without protection.
